Use Of Internal Hard Disk Drives In The Raid System - NEC Express5800/GT110e EXP280A User Manual

Chapter 2 Preparations
1.8

Use of Internal Hard Disk Drives in the RAID System

This section describes how to use the Hard Disk Drives installed in the HDD cage at the front of the server in
the RAID System.
N8103-128/149/150/151
location of the jumpers and setting, refer to the following.
N8103-128/149/150/151
Important
If you use Hard Disk Drives in the RAID System or change the RAID level,
initialize the Hard Disk Drives. If the Hard Disk Drive used in the RAID
System contains valuable data, be sure to backup the Hard Disk Drive
before installing the RAID Controller and configuring the RAID System.
Note
In the RAID System, use Hard Disk Drives that have the same specifications
(capacity, rotational speed, and standard) for each Disk Array.
Tips
Logical Drives can be created even with only one Physical Device.
To use this RAID System, jumper settings on motherboard are required. For the
Motherboard
Tips In the factory settings, the jumper switch is set to Disabled.
Express5800/GT110e User's Guide
1. Installing Internal Optional Devices
3 2 1 3 2 1
Enabled Disabled
SWRAID jumpers
51