HP Vectra VE5 2 User Manual page 55

Setup Item
Memory and Cache
Memory caching
Memory hole
Shadow/Cache ISA Option
ROMs
Hard Disk Drives
Hard disk drive 0
(xxxx MB)
Hard disk drive 1
(xxxx MB)
Hard disk drive 2
(xxxx MB)
Hard disk drive 3
(xxxx MB)
Translation method
On-board Bus IDE
adapters
Autotype fixed disk
Type
Cylinders*
Heads*
Sectors/Track*
Multi-sector transfers*
LBA mode control*
32 bit I/O
Transfer mode*
* Only available if "User"
mode has been selected
as "Type".
Default* Action
Both Controls internal (L1) and external (L2) memory
caching.
Disabled Sets a 1 MB memory hole between 15 MB and
16 MB if needed. You need at least 16 MB for
this option to be available.
Disabled Enables shadowing and caching for ISA "Non
PnP" Option ROMs for region X-Y, in order to
improve performance. Note that some Option
ROMs cannot be shadowed.
642 MB Configure IDE drive 0. It is not recommended to
connect a CD-ROM on a channel which already
has an IDE hard disk drive.
xxx MB
S ub-menu items for each of these fields are
given after "On-board Bus IDE adapters" in this
xxx MB
table.
xxx MB
Extended Select "Standard" only if you are running a UNIX
Operating System.
Both Enable or disable the on-board IDE
adapters."Primary" enables only the HDD data
cable (marked "HDD" next to the system board
attachment).
"Both" enables the HDD data cable and the CD-
ROM data cable (marked "CD-ROM" next to the
system board attachment).
Automatically attempts to detect and identify the
IDE drive when you press the Enter key.
User 642 MB Select "Auto" for automatic hard disk drive
detection. (To initiate automatic hard disk
detection, press the Enter key at the "Autotype
fixed disk" item). "User" allows you to edit all the
detected parameters. Select "CD" if drive is an
IDE CD-ROM, and "None" if there is no drive.
944 Sets the number of hard disk drive cylinders.
14 Sets the number of hard disk drive heads.
40 Sets the number of hard disk drive sectors per
track.
8 sectors Determines the number of sectors per block for
multiple sector transfers.
Enabled Enable or disable Logical Block Addressing
mode in place of Cylinder Heads Sectors.
Enabled Enable or disable 32 bit data transfer.
PI0 mode 3 Selects the hard disk drive transfer mode and
data transfer rate.