Table of Contents
Advertisement
When the toner cartridge replacement required (
replacement of the toner cartridge will be needed soon. Obtain a new
cartridge. When the toner cartridge replacement required (
blinks, the toner cartridge must be replaced before copying can be resumed.
Replace the toner cartridge by following the procedure below.
During a long copy run of a dark original, the
indicator may blink and the copier stop, even though
toner is left. The copier will feed toner up to 2 minutes
and then the START key (
Press the START (
4 or 5 times
Shutter
28
Downloaded from:
http://www.usersmanualguide.com/
TONER CARTRIDGE REPLACEMENT
) indicator will light up.
) key to restart copying.
Toner cartridge lock
release lever
Grip
Tape
) indicator lights up,
) indicator
Open the bypass tray. Lift slightly on the side cover and
1
slide the cover out until it stops.
Push gently on both sides of the front cover and open it.
2
Push the toner cartridge lock release lever and pull the
3
toner cartridge out. Remove the toner cartridge while
supporting it with the left hand at the green label position.
For disposal of the old toner cartridge, contact your dealer.
After removing the toner cartridge, do not shake it or tap
on it. Doing so may cause toner to leak from the
cartridge. Put the old cartridge immediately in the bag
contained in the box of the new cartridge.
Remove the new toner cartridge from the bag. Grasp the
4
cartridge on both sides and shake it horizontally four or
five times. After shaking the cartridge, remove the tape.
Grasp the grip when holding the cartridge. Do not hold
the cartridge by the shutter. Be sure to only shake the
cartridge before the tape is removed.
For best copying results, be sure to use only
SHARP products.
The package of SHARP toner has the Genuine
Supplies label.
GENUINE SUPPLIES
Advertisement
Table of Contents
