Mounting Location Of Circuit Card; Figure 4-1 Mounting Location Of Circuit Card - NEC NEAX2000 IVS2 Manual

MOUNTING LOCATION OF CIRCUIT CARD

This section explains the conditions for mounting circuit cards for the Remote PIM.
Figure 4-1 shows circuit card mounting slots allocated in the PIM.
AC/DC
PIM
PWR
DC/DC
PWR
*1 PN-CP15 card must be mounted in FP11 slot on Main Site PIM0 for Remote PIM system.
*2 PN-CP15 card in FP12 slot on Main Site PIM2, 4.
*3 PN-DAIA/PN-DAID card in the AP00-AP11 slots on Main Site PIM0, 2, 4.
For mounting the DAIA/DAID card on the AP11 slot, the CN connector on the DAIA/DAID
card should be used.
When the clock signal is supplied from the T1/E1 line, mount DAIA/DAID cards (DAIA0/
DAID0, DAIA1/DAID1) on PIM0 in order to receive the clock signal.
*4 PN-DAIB/PN-DAIE card in the MP slot on the Remote PIM.
*5 PN-DAIC/PN-DAIF card in the AP00-AP11 slots on Main Site PIM0, 2, 4, and in the AP00-
AP11 slots on the Remote PIM.
*6 PN-M10 card in the LT00-LT11 slots on Main Site PIM0, 2, 4, and on the Remote PIM.
2
NEAX2000 IVS Remote PIM System Manual
ND-70917 (E), Issue 1.0

Figure 4-1 Mounting Location of Circuit Card

LTC0
CHAPTER 4 CIRCUIT CARD INFORMATION
* *
3 5
LTC1
LTC2
BWB
FRONT
Mounting Location of Circuit Card
*
2
*
1
*
4
LTC3
Page 67