9.
Align the guide screw on the drive with the slot on the chassis. Slide the optical drive into the drive
bay until the two screw holes on the right side of the drive line up with the two screw holes on the
right side of the drive cage (1).
10.
Secure the optical drive by fastening two retainer screws through the holes in the right side of the
drive cage into the corresponding holes in the right side of the optical drive (2).
NOTE:
Extra retainer screws are provided on the front of the chassis under the hard drive cage.
The M3 metric retainer screws for optical drives are black. Refer to
on page 15
for an illustration of the retainer screws location.
Figure 22
Installing the Optical Drive
11.
Push in the latch holding the drive cage upright (1) and lower the drive cage all the way down (2).
Figure 23
Lowering the Drive Cage
12.
Connect the SATA data cable to the white system board connector.
Installing Additional Drives
Installing Additional Drives
19