Table of Contents
Advertisement
PREPARING THE BREWER FOR USE
NOTE - THE BREWER IS NOT READY TO PLUG IN.
Do NOT plug in until Step #3.
Step 1
Raise the hinged flip-lid.
NOTE: The post protruding from the screen is
connected to a stopper which controls the flow of
water into the tank. When lid is closed (post depressed),
the stopper is raised and water will flow into the tank.
Step 2
Slide an empty brew funnel into the brewer. Pour
one carafe full of water into the screened area on top
of the brewer (there is no need to have the lid on the
carafe at this time). Place carafe in position on the
brewer. Close lid. Wait three minutes to allow the
water to flow into the tank. Repeat this process.
When the tank is full, some water will flow through the
funnel and into the carafe. Leave the carafe in place.
Step 3
Plug in the brewer.
Step 4
Press the bottom of the vacation switch, located on the
lower left side of the brewer, to the "ON" (lower) position.
The vacation switch controls power to the tank heater.
Initially you will have to wait approximately fifteen
minutes in order for the water to reach brew
temperature.
Empty any water that has collected in the carafe.
You're not done yet! The next page leads you through the five
easy steps to 'BREWING DELICIOUS COFFEE'
OF
F
6
OF
F
P2559
OFF
OFF
P2561
P214
F
OF
OF
F
P2560
Advertisement
Table of Contents
