Preparing The Brewer For Use - Bunn B10 Use And Care Manual

PREPARING THE BREWER FOR USE

NOTE - THE BREWER IS NOT READY TO PLUG IN.
Do NOT plug in until Step #3.
Step 1
Raise the hinged flip-lid.
NOTE: The post protruding from the screen is
connected to a stopper that controls the flow of water
into the tank.When lid is closed (post depressed), the
stopper is raised and water will flow into the tank.
Step 2
Slide an empty brew funnel into the brewer under
the warmer switch.Pour one decanter full of water into
the screened area on top of the brewer. Place decanter
on the warmer. Close lid.Wait three minutes to allow
the water to flow into the tank. Repeat this process.
When the tank is full,some water will flow through the
funnel and into the decanter.
Step 3
Plug in the brewer.
Step 4
Press the bottom of the vacation switch, located on
the lower left side of the brewer, to the "ON" (lower)
position.
The vacation switch controls power to the tank heater.
Initially you will have to wait approximately fifteen minutes
in order for the water to reach brew temperature.
Empty any water that has collected in the decanter.
The next page leads you through the five easy steps to
'BREWING DELICIOUS COFFEE'
6
P2240
P2247
P214
O FF
P219