Table of Contents
Advertisement
GENERAL INFORMATION
NOTE - THE BREWER IS NOT READY TO PLUG IN
Improper installation will result in permanent damage and void the
limited warranty. Read & follow the instructions on the next page.
• This brewer is designed to remain plugged in at all times
(except during initial installation or when cleaning).
• A vacation switch is provided on the lower left side to completely shut
off all electrical components when your plans take you away from
home for three or more days. Safety features, designed into the BUNN®
coffee brewer, make the daily use of this switch unnecessary.
• Whenever the brewer has been shut off or unplugged, fill the tank with
water and allow the water in the tank to heat to the proper temperature
before using (about fifteen minutes or until the heating sound stops).
®
• Your BUNN
coffee brewer has a specially designed tank to keep the
water at the proper temperature. This constant supply of hot water
assures the correct method of brewing coffee, in less than three
minutes.
• The brewed coffee flows into a non-heated thermal carafe
server. The stainless steel construction will hold coffee at
serving temperature for 2 hours minimum.
• The carafe lid reduces coffee evaporation and temperature loss.
• While coffee is being brewed, the newest water in the tank is heated to
the proper temperature and held until needed.
• When the brewer is not in operation, the flip lid should remain closed.
Leaving the lid open may cause an unexpected drip of water from the
sprayhead once cold water has been poured into the top of the brewer.
• Use CAUTION when dispensing hot water from the brewer. The water
is approximately 50°F hotter than that available from your hot water
faucet and is always available for other uses.
• The brewer is equipped with a polarized cordset. One blade of the plug
is slightly larger than the other. This is a safety feature and allows the
plug to fit into the outlet only one way. If you are unable to insert the
plug into the outlet, try turning it over. If the plug still does not fit,
contact an electrician to update your outlet. Do not attempt to bypass
the safety aspect of this polarized plug.
• The sprayhead will periodically become loose. Using extreme caution
not to burn yourself, retighten the sprayhead with your finger tips.
NOTE- A severe burn may result if the sprayhead becomes
loose and falls off while brewing.
(See Page 6)
5
Advertisement
Table of Contents
