Table of Contents
Advertisement
6
Slide the drive completely into the bottom shelf and secure it with the screws provided
with the device.
7
Replace the side bezel.
8
Connect the data and power cables to the rear of the drive and to the PC (refer to the
cables and instructions that come with the tape drive).
9
If a device was removed from the middle shelf, replace it.
10 If no device was removed from the middle shelf, replace the RFI bezel.
11 Install any other accessories before replacing the cover. Reconnect all cables and power
cords.
12 Verify the new configuration by checking the HP Summary Screen. Refer to the "HP
Summary Screen" in chapter 3.
Advertisement
Table of Contents
