Table of Contents
Advertisement
5
Connect the data and power cables to the rear of the device installed in the middle shelf.
The connectors are shaped to go in one way only . If you are installing an IDE CD-ROM
drive, connect the drive to the CD-ROM data cable. This data cable should be connected
to the connector marked "CD-ROM" on the system board. If you are not sure which
connector to use, refer to "Connecting IDE Devices" earlier in this chapter.
6
Install any other accessories before replacing the cover. Reconnect all cables and power
cords.
7
Verify the new configuration by checking the HP Summary Screen. Refer to the "HP
Summary Screen" (chapter 3).
WARNING:
Do not open the CD-ROM drive enclosure as
there is a danger of electric shock, and the laser
beam light could harm your eyes. Service should
be carried out by qualified personnel. This PC is
a class 1 laser product. To avoid discomfort from
unexpected noise, always turn the volume down
before connecting headphones or speakers.
Listening to loud sounds for prolonged periods
may permanently damage your hearing. Before
putting on headphones, place them round your
neck and turn the volume down. When you put
on the headphones, slowly increase the volume
until you find a comfortable listening level and
leave the volume control in that position.
Advertisement
Table of Contents
