Table of Contents
Advertisement
8
Align the drive with the holes in the bottom of the PC. Support the drive with your hand
while securing the drive with the four screws provided.
9
Support the power supply with your hand and very carefully return the PC to the upright
position.
10 Connect the data and power cables to the rear of the drive. The connectors are shaped to
fit one way only . If you are not sure which connector to use, refer to "Connecting IDE
Devices" earlier in this chapter.
11 If a device was removed from the middle shelf, replace it.
12 If no device was removed from the middle shelf, replace the bezel.
Advertisement
Table of Contents
