Options And Accessories - Hatco Glo-Ray GRSDS Series Installation And Operating Manual

English
Digital Temperature Controller
Units may be equipped with an optional digital temperature
controller that regulates and displays the base/shelf
temperature(s). Use the following procedures to operate the
digital temperature controller.
NOTE: This option is factory installed only, not available for
retrofit.
NOTE: Units manufactured for use outside the United States
and Canada will have digital temperature controllers
that indicate temperature in Celsius (°C).
"out 1"
SET Down Arrow
Key
Key
Digital Temperature Controller
1. Move the unit Power I/O (on/off) switch to the I (on)
position.
• The digital temperature controller will energize and
the current temperature of the heated base/shelves
will appear on the display. CAUTION! Some exterior
surfaces on the unit will get hot. Use caution when
touching these areas.
• The phrase "out 1" will appear in the upper left corner of
the display to show that the base is in heat mode.
2. Press and release the
temperature will be shown on the display and "out 1" will
flash in the upper left corner.
3. Press the key or
change the setpoint temperature. If no key is pressed
within 15 seconds, the display will revert to the current
temperature of the heated base(s)
4. Press the key or wait 15 seconds to lock in the new
setpoint temperature. The setpoint temperature range of
the controller is from room temperature to the maximum
operating temperature of the unit.
Locking/Unlocking the Digital Temperature
Controller
The keys on the digital temperature controller can be locked to
prevent unauthorized changes to the settings.
To lock the keys of the digital temperature controller:
• Press and hold both the
same time for over two seconds. The message "Loc" will
appear on the display.
To unlock the keys of the digital temperature controller:
• Press and hold both the
same time until the message "UnL" appears on the display.
Form No. GRSDM-0121
Fahrenheit
Symbol
Up Arrow
Key
key. The current setpoint
key within 15 seconds to
key and key at the
key and key at the

OPTIONS AND ACCESSORIES

Sneeze Guards
Optional sneeze guards are available for the all models.
GRSDH models can be fitted with sneeze guards above each
shelf on both sides of the unit. GRSDS and GRSDS/H models
can be fitted with sneeze guards above each shelf on the
customer side of the unit only. Use the following procedure to
install sneeze guards.
1. Remove the screws from the face of the unit that align with
the holes in the sneeze guard.
2. Align the holes on the sneeze guard with the screw holes
on the unit.
3. Insert the screws removed in step 1 through the sneeze
guard and into the unit.
4. Tighten the screws until the sneeze guard is secure. Do
not over-tighten the screws.
GRSDS Model Sneeze Guard Installation
Display Sign Holder
A display sign holder (sign not included) is available
for installation on the top or intermediate shelf. The sign holder
is installed by simply attaching the magnetic side of the sign
holder to the desired shelf.
Magnet
Display Sign Holder
15
Sneeze Guard
Screw
Sign Holder