Installation; General - Hatco Glo-Ray GRSDS Series Installation And Operating Manual

English

General

Glo-Ray Merchandising Display Warmers are shipped with
®
most components pre-assembled. Care should be taken when
unpacking shipping carton to avoid damage to the unit and
components enclosed.
WARNING
ELECTRIC SHOCK HAZARD: Unit is not weatherproof.
Locate unit indoors where ambient air temperature is a
minimum of 70°F (21°C).
Fire Hazard: Locate unit a minimum of 1" (25 mm) from
combustible walls and materials. If safe distances are not
maintained, discoloration or combustion could occur.
CAUTION
The National Sanitation Foundation (NSF) requires that
units over 36" (914 mm) in width or weighing more than
80 lbs. (36 kg) either be sealed to or raised above the
installation surface. If unit cannot be sealed at the point
of use, 4" (102 mm) legs are included to allow for proper
cleaning access below unit.
1. Remove the unit from the carton.
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
IMPORTANT OWNER INFORMATION section for
details.
2. Remove tape and protective packaging from all surfaces
of the unit.
NOTICE
Do not lay unit on the side with the control panel. Damage
to unit could occur.
Units with two power cords must each be plugged into
individual branch circuits.
Locate the unit in an area where the ambient air temperature
is constant and a minimum of 70°F (21°C). Avoid areas
that may be subject to active air movements or currents
(i.e., near exhaust fans/hoods, air conditioning ducts, and
exterior doors).
3. Carefully lay the unit on its side
and install the four rubber feet.
• Thread a foot stud into the
hole at each corner on the
bottom of the unit. Tighten
securely.
• Slip a rubber foot over each
foot stud.
NOTE: If 4" (102 mm) legs are
required, refer
OPTIONS AND ACCESSORIES section in this
manual for installation instructions. 4" (102 mm) legs
are standard on single shelf models 36" (1041 mm)
and wider, all dual shelf models, and all triple shelf
models.
Form No. GRSDM-0121
Foot
Stud
Rubber
Foot
to the
4. Slide each glass side panel into the upper channel, then
carefully lower the panel into the lower channel.
Glass Side Panel Installation
5. Install the channel dividers and product divider rods.
• Position the channel dividers onto the locator pins on the
front edge and back edge of the unit.
• Place the product divider rods into the channel dividers.
The rods can be adjusted easily to separate holding
areas as needed.
Locator Pin
Channel
Divider
Installing Product Divider Rods
NOTE: Unit must be transported in the upright position.
6. Place the unit in the desired location.
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 70°F
(21°C). Avoid areas that may be subject to active air
movements or currents (i.e., near exhaust fans/hoods,
air conditioning ducts, and exterior doors).
• Make sure the unit is at the proper counter height in an
area convenient for use.
• Make sure the countertop is level and strong enough to
support the weight of the unit and food product.
• Make sure all the feet on the bottom of the unit are
positioned securely on the countertop.
11

INSTALLATION

Product
Divider Rod