Adding The Texture Module To The Visualize Fx4 Board - HP Kayak XW U3-W3 User Manual

riotx.bk : riotx-us.fb4 Page 8 Tuesday, December 16, 1997 3:08 PM
Reuse this small screw when
installing the texture module
Ensure that the stand-off
(where the screw goes in)
remains fixed to the heat sink
1 HP VISUALIZE fx4 Texture Module User's Guide
Installing the Texture Module

Adding the Texture Module to the VISUALIZE fx4 Board

1 Remove the four screws from the blank stiffener board, then remove
the board. (You can use a Torx
screwdriver of the correct size.) Keep the smallest screw (shown
below) to secure the texture module.
2 Using both hands, carefully remove the terminator from the
VISUALIZE fx4 board. Store the terminator in a safe place (you may
need it at a later date).
3 Before installing the texture module, ensure that all four screws on
the texture module are fully retracted or removed.
8 English English
TM
screwdriver or a flat-blade
Blank Stiffener Board
Terminator