Connecting An External Scsi Accessory - HP Kayak XA05 User Manual

ashaki.bk : ashak-1.fb4 Page 6 Wednesday, July 15, 1998 6:13 PM
WARNING
NOTE
1 Setting Up and Using Your HP PC Workstation
Connecting an External SCSI Accessory (Selected Models Only)
To avoid discomfort from unexpected noise or static, always turn
down the volume before connecting headphones or speakers.
Listening to loud sounds for prolonged periods may permanently
damage your hearing.
Before putting on headphones, place them around your neck and turn
down the volume. When you put on the headphones, slowly increase
the volume until you find a comfortable listening level, then leave the
volume control in that position.

Connecting an External SCSI Accessory

(Selected Models Only)
An external SCSI device is connected as follows:
1 You should assign an unused SCSI ID to the accessory. SCSI IDs
range from 0 to 15 for wide 16-bit SCSI. The SCSI ID 0 is reserved for
the first SCSI hard disk drive and SCSI ID 7 is reserved for SCSI
controller (the default for narrow and wide SCSI devices).
Refer to the manual provided with the SCSI accessory for
instructions on selecting a SCSI ID.
You don't need to set a SCSI ID for Plug and Play SCSI devices (SCSI
devices which support the SCAM protocol).
Windows 98 does not support SCAM.
2 Make sure the SCSI accessory is terminated correctly—either
internally or by a terminating resistor (refer to the manual provided
with the SCSI accessory).
6 English