The Hp Summary Screen And Setup Program - HP Kayak XA05 User Manual

ashaki.bk : ashak-3.fb4 Page 38 Wednesday, July 15, 1998 6:13 PM
3 Troubleshooting Your HP PC Workstation

The HP Summary Screen and Setup Program

The HP Summary Screen and Setup Program
This section introduces the HP Summary Screen and the HP Setup
program. You can use the Summary Screen and the Setup program to
configure your PC Workstation and solve configuration problems with
your PC Workstation.
Starting the HP Setup Program
1 Turn on the display and then the computer. If the PC Workstation is
already turned on, save your data and exit all programs, then restart
the PC Workstation. Consult your operating system documentation
for any special instructions concerning turning off and then
restarting your PC Workstation.
2 Press while
If you fail to press
you will need to restart your PC Workstation to go through the POST
again so you can press
The opening screen of the PC Workstation's Setup program is
displayed.
Viewing the HP Summary Screen
Check your PC Workstation's configuration each time after you install,
remove, or upgrade accessories. To check the configuration:
1 Turn on the display and then the PC Workstation. If the PC
Workstation is already turned on, save your data and exit all
programs, then restart the PC Workstation. Consult your operating
system documentation for any special instructions concerning
turning off and then restarting your PC Workstation.
2 While the start-up logo appears on your display, press
takes you to the HP Summary Screen. (To go immediately into the
Setup program, and bypass the Summary Screen, press
of ). The Summary Screen is displayed for only a short time. To
retain the screen (until you decide to leave it), press
38 English
is displayed at the bottom of the screen.
Setup
in time and the start-up process continues,
.
. This
instead
.