Usb Connectors; Keyboard; Hp Mouse; Hp Hub For Usb Devices - HP j6700 Getting Started Manual

System Overview

USB Connectors

USB Connectors
The two Universal Serial Bus (USB) connectors support only the HP
keyboard, mouse and hub (D6804A). You can connect the HP keyboard,
mouse and hub in either of the USB connectors.
The mouse and keyboard were shipped with your system unit, and the
HP hub can be ordered separately. Note that you should consult the
documentation that accompanies each input device for specific
information concerning its use.
For more information on the Universal Serial Bus, use your browser and
the following URL:
http://www.usb.org

Keyboard

The USB connector provides an interface for the keyboard to the system.
This keyboard provides the standard keys found on most PC keyboards.

HP Mouse

The HP mouse (USB) has a left, middle and right buttons that function
the same as most mice. For general information on the various cursor
shapes associated with different areas of HP CDE while using a mouse,
see the Using Your HP Workstation document.

HP Hub for USB Devices

The HP USB hub provides you with the ability to connect more than two
USB devices to your workstation, as well as with the ability to extend
your USB device's cable length. As an example, you may desire to locate
your workstation's keyboard and mouse at a greater distance from your
workstation, but your keyboard and mouse cables are not long enough.
To increase the cable length of your keyboard and mouse, you make use
of the USB hub's extra cable length and connect the hub's cable to one of
the two connectors on the back of your workstation. You then connect the
keyboard and mouse into their separate connectors on the USB hub.
30 Chapter 1