When Your System Arrives - HP J class 3 Supplementary Manual

planning your site

when your system arrives

WARNING
when your system arrives
See the hp visualization center sv6 Installation and User's Guide for
more installation details. See
/opt/graphics/OpenGL/doc/sv/Troubleshoot.pdf for additional help.
These files are also available on the Recovery CD under /Docs/*.pdf.
1. Verify Your Hardware Setup
The systems will arrive fully configured. There are just a few physical
connections that have to be made after unpacking.
• Unpack racks
— Verify that boxes are undamaged before opening.
— Check the packing slip and verify that you received all
equipment on the list.
— Position the racks.
Before doing any further configuration, pull out or bolt on
the anti-tip plate at the bottom of each rack. Failure to do
so will pose a serious safety risk, as the rack could tip over.
• Connect Extras
— If you have multiple racks, connect them as indicated by the
labels on the disconnected cables.
— Power & I/O devices:
See power, space, and cooling requirements in this
document.
Plug in power for each rack.
Attach keyboard and mouse to the system labeled Master.
Attach the stereo emitter to the controller card of the
compositor (optional)
Attach your display device to the output card of the
compositor via a standard analog monitor cable.
— Network
20 Chapter 2