Husqvarna FS 600 E Operator's Manual page 16

3. Use the handle (D) to lift the blade guard and install
the blade guard onto the support (E).
D
4. Install the screw (F) for the blade guard.
G
F
5. Connect the water hose (G).
16
E
6. Install the flange cover on the opposite side of the
product and tighten the 2 screws.
To remove the blade guard
1. Stop the motor. Refer to
20 .
2. Remove the blade guard in the opposite sequence
of how it was installed. Refer to
guard on page 15 .
To set the cutting depth indicator
The indicator must be calibrated before you use the
product.
Note:
The lever for the cutting depth wheel must
always be locked when the cutting depth wheel is not
in use.
1. Turn the cutting depth wheel until the cutting blade
slightly touches the ground. Push the lever to lock
the cutting depth wheel.
To stop the product on page
To install the blade
1620 - 003 - 28.02.2022