Husqvarna FS 600 E Operator's Manual page 15

15. Unlock the blade guard from the carabiner (J) and
lower the blade guard front (K).
16. Put the blade guard latch (L) on the front bolt of the
blade guard. Tighten the front bolt (M) of the blade
guard.
CAUTION:
product without the blade guard front
lowered and the blade guard latch
engaged. Do not use the product if the
parts are damaged.
17. Make sure that the blade screw on the opposite side
of the product is tightened.
18. Start the product. Refer to
page 19 .
19. Listen for unusual sounds. If there are unusual
sounds, remove the cutting blade.
a) Examine the cutting blade for damages.
b) Install the cutting blade again. Replace the
cutting blade if it is damaged.
To remove the cutting blade
WARNING:
diamond blades, let the product become
cool and use protective gloves. Diamond
blades are very hot after use.
• Remove the cutting blade in the opposite sequence
of how it was installed. Refer to
blade on page 13 .
To install the blade guard
The blade guard must be installed on the same side of
the product as the cutting blade. If it is necessary, move
the blade guard latch to correct side of the blade guard.
1620 - 003 - 28.02.2022
K
M
J
L
Do not operate the
To start the product on
When you remove
To install a cutting
1. If the blade guard latch is not installed on the correct
side of the blade guard, do the procedure that
follows.
a) Loosen the 2 screw for the flange cover and
remove the flange cover.
b) Loosen the front bolt (A) on the blade guard and
lift the blade guard latch (B).
C
c) Remove the rear bolt and the blade guard latch
(C).
2. Move the blade guard latch to the opposite side of
the blade guard. Do the procedure that follows.
a) Install the blade guard latch and tighten the rear
bolt.
b) Put the blade guard latch on the front bolt of the
blade guard. Tighten the front bolt (A).
CAUTION:
product without the blade guard latch
engaged. Do not use the product if the
parts are damaged.
B
A
Do not operate the
15