Husqvarna FS 600 E Operator's Manual page 13

Water cooling system
Always use water during operation to keep the
temperature of the diamond blades down. The water
cooling system also increases the lifetime of the
diamond blades and prevents dust buildup.
Make sure that the water supply is not clogged.
Diamond blades for wet cutting
WARNING:
dimension that is specified for the current
blade dimension. Do not use blade flanges
that are damaged.
During the operation, the friction causes the diamond
blade to become very hot. If the diamond blade
becomes too hot, it will decrease the blade tension or
make the core crack.
Let the diamond blade become cool before you touch it.
• Diamond blades for wet cutting must be used with
water to keep the diamond blade core and segments
cool during cutting. Diamond blades for wet cutting
can not be used dry.
• If you use diamond blades for wet cutting without
water, the diamond blade can become too hot. This
gives bad performance, blade damage and is a
safety risk.
To adjust the handle height
The height of the handle can be adjusted to the correct
height.
1. Loosen the screws (A) on each side of the product.
B
A
2. Set the position for the necessary work height (B).
3. Tighten the screws (A).
1620 - 003 - 28.02.2022
Always use a blade flange
To install a cutting blade
The cutting blade can be installed on the right side and
the left side of the product.
CAUTION:
cutting blade if it is installed opposite to
the direction of rotation. Make sure that the
cutting blade rotates in the direction of the
arrows shown on the cutting blade.
Note:
The lever for the cutting depth wheel must
always be locked when the cutting depth wheel is not
in use.
1. Stop the motor and disconnect the product from the
mains socket.
2. Turn the cutting depth wheel clockwise to fully lift the
cutting blade. Push the lever to lock the cutting depth
wheel.
3. The blade guard must be installed on the same side
of the product as the cutting blade. If the blade guard
is not installed on the correct side, refer to
the blade guard on page 15 .
Risk of damage to the
To install
13