Power Management Setup - ECS L4S5A3 Manual

USB0/USB1/USB2 ACCESS INTERFACE (EDB Bus)
This option determines whether the USB0/USB1/USB2 access interface is the
embedded bus or the PCI bus.
USB2.0 ACCESS INTERFACE (EDB BUS)
This option determines whether the USB2.0 access interface is the embedded
bus or a PCI bus.
Audio ACCESS INTERFACE (EDB BUS)
This option determines whether the audio access interface is the embedded
bus or a PCI bus.

Power Management Setup

This option lets you control system power management. The system has vari-
ous power-saving modes including powering down the hard disk, turning off
the video, suspending to RAM, and software power down that allows the sys-
tem to be automatically resumed by certain events.
Power Management Timeouts
The power-saving modes can be controlled by timeouts. If the system is inac-
tive for a time, the timeouts begin counting. If the inactivity continues so that
the timeout period elapses, the system enters a power-saving mode. If any
item in the list of Reload Global Timer Events is Enabled, then any activity on
that item will reset the timeout counters to zero.
Wake Up Calls
If the system is suspended, or has been powered down by software, it can be
resumed by a wake up call that is generated by incoming traffic to a modem, a
LAN card, a PCI card, or a fixed alarm on the system realtime clock,
Phoenix – AwardBIOS CMOS Setup Utility
ACPI function
ACPI Suspend Type
Video Off Option
Video Off Method
MODEM Use IRQ
Hot Key Function as
PS2KB Wakeup from S3
USB S3 Wakeup Function
HDD Off After
Power Button Override
Power State Resume Control
PM Wake Up Events
Delay Prior to Thermal
↑ ↓ → ← : Move
Enter : Select
Help F5:Previous Values
Power Management Setup
[Enabled]
[S1(POS)]
[Susp, Stby --> Off]
[DPMS Supported]
[Auto]
[Power Off]
[Hot key]
[Disabled]
[Disabled]
[Instant-Off]
[Always Off]
[Press Enter]
[None]
+/-/PU/PD:Value: F10: Save ESC: Exit F1:General
F6:Fail-Safe Defaults
39
Item Help
Menu Level
F7:Optimized Defaults