Table of Contents
Advertisement
28.2. Introduction
The base unit uses a 128K bit serial EEPROM (IC3) for storing volatile parameters.
All parameters are set up before the base leaves the factory. Some of these are vital
for the operation of the hardware so a set of default parameters is programmed
before the actual hardware fine-tuning can be initiated. This document lists all
default settings with a short description.
In the tables below values in a range that are similar are not repeated; i.e. Address
00 to 01 contains the value 00 simply means that the value 00 is repeated in all
addresses in the range. All values in this document are in hexadecimal notation.
Initial Type
F
The data initialized by only F command
0
The data initialized by F and 0 command
1
The data initialized by F, 0 and 1 command
2
The data initialized by all command (F,0,1,2)
Country
Setting
x
Default - no specific country setting, so revert to default value.
28.3. EEPROM Layout
28.3.1. General Setup1
Description
Description
130
Advertisement
Table of Contents
