Table of Contents
Advertisement
Jumper
Description
JBT1
Clear CMOS
JPB1
Baseboard Management Controller (BMC)
Enable
JPG1
VGA Enable
JPME2
Manufacture (ME) Mode Select
JVRM1/2 I2C Bus for VRM 1/2
JWD1
Watch Dog Timer Enable
Connectors
Battery
COM1
JF1
JSD1
JTPM1
IPMI_LAN
SIOM
S-SATA3
(CPU2) Slot1
(CPU2) Slot2
SXB2
SXB1
UID SW
USB0/1 (3.0)
VGA
X10DRT-PS Motherboard LED Indicators
LED
LE6
BMC_HB_LED1 (BMC Heartbeat LED) Green (Blinking): BMC normal
UID LED1 (Unit_Identifier LED)
X10DRT-PS Motherboard Jumpers
X10DRT-PS Motherboard Connectors
Description
Onboard CMOS battery (See more info in Chapter 3)
COM port header
SMC proprietary front control panel header
SATA DOM (Device_On_Module) power connector
TPM (Trusted Platform Module)/Port 80
IPMI_Dedicated LAN connector
CPU1 PCI-E 3.0 x 16 slot for proprietary add-on module use
SATA DOM (Disk-On-Module) with power-pin connector
PCI-E 3.0 x16 Slot supported by CPU2
PCI-E 3.0 x8 Slot supported by CPU2
I-SATA 0-5/PCI-E 3.0 x8 Slot supported by CPU1
S-SATA 0-2/PCI-E 3.0 x16 Slot supported by CPU2
UID (Unit Identifier) Switch (JUIDB1)
Back Panel USB 3.0 Ports 0/1
Backpanel VGA Port
1-5
Default Setting
See Chapter 2
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Normal)
1-2 BMC, 2-3:PCH
Pins 1-2 (RST)
State
Orange: Standby power ready
Green: All power RAMP normal
Red: One or more power regulators failed
Blue: (On/Blinking) Unit identified
Chapter 1: Overview
Advertisement
Table of Contents
