Cannot Print Properly From The Digital Camera - Canon PIXMA iP2000 Quick Start Manual

Cannot Print Properly from the Digital Camera

The following are the possible errors that may occur when printing directly from a digital still
camera or digital video camcorder*, and the countermeasures to eliminate them.
* Hereafter, the digital still camera and digital video camcorder are collectively called a digital camera or camera.
Camera Error Message
Printer in use
Printer warming up
No paper
Paper error
Paper Jam
Printer cover open
No Print Head
Waste tank (Waste ink
2
absorber* ) full
Ink is low
Ink tank is empty
Printer error
1
* To resume printing, you can press the R R ESUME/CANCEL button on the printer instead of selecting C C ontinue.
2
* The waste ink absorber absorbs ink used during cleaning.
Possible Cause
Images are being printed from
the computer
The printer is warming up
No paper is loaded
The Paper Output Tray is
closed
A paper jam occurrs in the
printer
The Front Cover is open
No Print Head is installed (The
POWER lamp on the printer
flashes five times)
The Print Head is defective
(The P P OWER lamp on the
printer flashes five times)
2
The waste ink absorber*
nearly full
It is about time to replace the
ink tank with a new one
Replace the ink tank with a
new one
An error requiring servicing
might have occurred (The
POWER lamp on the printer
flashes alternately orange and
green)
Wait until printing ends. The printer automatically starts
printing the images from the camera after completing the
current printing.
Wait until warm-up ends. When it is ready, the printer starts
printing automatically.
Load the paper in the Auto Sheet Feeder of the printer and
1
select C C ontinue* in the display on your camera. The Front
Sheet Feeder cannot be used for printing.
Open it. Printing will resume.
Select C C ancel in the display on your camera to cancel the print
job. Remove the jammed paper, load new media, and press the
RESUME/C C ANCEL button.
Close the Front Cover.
Install a Print Head according to the
If a Print Head has already been installed, remove it, check that
its contacts are clean, and then reinstall it.
If the problem still remains, the Print Head may be defective.
Contact the Customer Care Center.
is The printer has a built-in waste ink absorber to hold the ink
used during Print Head cleaning. This error message indicates
that the waste ink absorber is nearly full.
Selecting C C ontinue*
printing. Printing can be continued for a while, but printing
cannot be continued when the waste ink absorber becomes full.
Contact the Customer Care Center as soon as possible.
1
Select C C ontinue* in the display on your camera to resume
printing.
Printing resumes once the Front Cover is closed after ink tank
replacement.
You can continue printing by selecting C C ontinue*
on your camera with the ink tank empty. But, it is recommended
you replace it with a new one immediately after printing. It may
damage the printer if you continue printing with empty ink
tanks.
Select C C ancel in the display on your camera to cancel the print
job.
Disconnect the cable connected to the camera, turn off the
printer, and unplug the power cord of the printer from the
outlet. Leave the printer for a while, plug the power cord of the
printer back in the outlet, turn on the printer, and connect the
camera to the printer.
If the error persists, contact the Customer Care Center.
Troubleshooting
Try This
Easy Setup Instructions
1
in the display on your camera resumes
.
1
in the display
71