Loading Rolls In The Printer; Removing The Roll From The Printer - Canon imagePROGRAF iPF8300S Basic Guide No.2 Basic Manual

Error Messages
Error Message
Borderless printng not possible.
Before borderless printing,
move the blue platen switch.
Prepare for parts replacement.
Parts replacement time has
passed.
Move the blue platen switch
No.xx to the right. (xx represents
a number)
Blue platen switch is dirty.
Cause
The print job received specifies
a type or width of paper that is
not compatible with borderless
printing.
The loaded paper is a size not
compatible with borderless
printing.
The blue Switch on the platen was
set to the side opposite ● when a
borderless print job was received.
It is almost time to replace
consumables for which service is
required.
It is past the recommended time
to replace consumables for which
service is required.
The printer has detected that the
blue Switch on the platen needed
in maintenance during printing is
set away from the ● mark.
The blue Switch on the platen is
dirty.
40
Corrective Action
Follow these steps to change the settings of the print
job to enable borderless printing.
1. Press ▲ or ▼ to select Stop Printing , and then
press the OK button.
2. Make sure the correct printer driver for the printer is
selected and try printing again.
For information on types of paper compatible with
borderless printing, refer to the Paper Reference
Guide .
(→"Types of Paper," User's Guide)
Select None when you have set Detect Mismatch on
the control panel to Warning .
However, note that this error may cause paper jams
and affect the printing quality.
Press ▲ or ▼ to select Print With Border , and
then press the OK button to continue printing. The
document will be printed with a border.
Press ▲ or ▼ to select Stop Printing , and then press
the OK button to stop printing.
Replace the paper with paper compatible for
borderless printing as follows.
1. Press ▲ or ▼ to select Change Paper , and then
press the OK button to remove the roll.
(→

, Removing the Roll from the Printer)

(→"Removing the Roll Holder from Rolls," User's
Guide)
2. Replace the paper with paper compatible for
borderless printing.
(→ , Attaching the Roll Holder to Rolls)
(→

, Loading Rolls in the Printer)

The printer now starts printing the print job.
For information on types of paper compatible with
borderless printing, refer to the Paper Reference
Guide .
(→"Types of Paper," User's Guide)
Press ▲ or ▼ to select Print With Border , and
then press the OK button to continue printing. The
document will be printed with a border.
Before borderless printing, set the blue Switch on the
platen to the ● side.
(→"Setting the Blue Switch on the Platen," User's
Guide)
You can continue to use the printer for some time
until Parts replacement time has passed. will be
displayed.
Contact your Canon dealer for assistance.
Contact your Canon dealer for assistance.
Set blue Switch on the platen that is identified in the
message toward the ● side.
(→"Setting the Blue Switch on the Platen," User's
Guide)
Open the Top Cover and clean the blue Switch on
the platen.
(→ , If Paper is Soiled)