Canon imagePROGRAF iPF6300S Basic Guide No.2 Basic Manual page 34

Error Messages
Error Message
GARO Wxxxx (x represents a
number)
No ink left.
Ink insufficient.
Not much ink is left.
Close Ink Tank Cover
No ink tank loaded.
Wrong ink tank.
Remaining level of the ink
cannot be correctly detected.
Check printed document.
ERROR Exxx-xxxx (x represents
a letter or number)
Cannot adjust paper feed.
Cause
There is a problem with the print
job.
There is no ink left.
The ink level is low, so you cannot
print, clean the Printhead , or do
other operations that require ink.
Not much ink is left.
The Ink Tank Cover is open.
There is no Ink Tank in the printer.
There is a problem with the Ink
Tank .
The Ink Tank in the printer is
incompatible.
Ink level detection cannot work
correctly if you use refill ink tanks.
The Printhead nozzles are
becoming clogged.
An error requiring service may
have occurred.
The Printhead nozzles are
clogged.
Highly transparent film is loaded
that cannot be used for automatic
feed amount adjustment.
34
Corrective Action
Try printing again, using the correct printer driver.
It is also possible to continue printing in this state.
However, you may not be able to obtain the desired
printing results.
Open the Ink Tank Cover and replace the Ink Tank for
which the Ink Lamp is flashing.
(→ , Replacing Ink Tanks)
Press ▲ or ▼ to select Rep. Ink Tank , and then
press the OK button. Replace the Ink Tank that is low
with a new Ink Tank .
(→ , Replacing Ink Tanks)
Press ▲ or ▼ to select Continue to print , and then
press the OK button to resume printing. However,
note that this error may affect the printing quality.
Press the OK button and replace the Ink Tank that is
low with a new Ink Tank .
(→ , Replacing Ink Tanks)
Prepare a new Ink Tank .
We recommend replacing the Ink Tank with a new Ink
Tank at this point if you plan to print large-format or
high-quantity jobs.
Close the Ink Tank Cover .
Load the Ink Tank .
(→ , Replacing Ink Tanks)
Replace it with a new Ink Tank .
(→ , Replacing Ink Tanks)
Load an Ink Tank specified for use with the printer.
(→ , Replacing Ink Tanks)
The refill ink tank can no longer be used. See the
section " Ink level detection " and take the appropriate
action. (→"Ink Level Detection," User's Guide)
If printing is faint, clean the Printhead .
(→ , If Printing is Faint)
Write down the error code and message, turn off the
printer, and contact your Canon dealer for assistance.
Execute Adj. Quality again, as follows.
1. Press the OK button to clear the error.
2. Print a test pattern to check the nozzles.
(→"Checking for Nozzle Clogging," User's Guide)
3. Clean the Printhead if the nozzles are clogged.
(→ , If Printing is Faint)
4. Execute Adj. Quality again.
(→ , If Banding Occurs)
Press the OK button to clear the error, and then adjust
the feed amount manually.
(→"Manual Banding Adjustment (Adj. Quality)," User's
Guide)