Descaling - Sunbeam EMM2900 User Manual

Descaling

After continued use, your machine may
develop a build up of mineral deposits and will
require occasional descaling. We recommend
descaling your machine every 4-6 months,
although this period will depend on the
hardness of water and frequency of use.
Important: Your machine will let you know
when it's time to descale. The STANDBY,
1 CUP, 2 CUP and STEAM buttons will
flash 5 times. You will need to descale
your machine and reset it to cancel the
descale warning.
Descaling solution
Sunbeam Descaler (EMA0015CL)
are available for purchase from Sunbeam.
Details are on the back page.
Preparing for descaling
• Fill water tank with solution
- Fill water tank to the MAX level and add one
Sunbeam Descaler sachet. Allow powder to
fully dissolve.
• Place containers
- Place 2 large cups under the group head and
steam wand.
• Power
Ensure that:
- The power plug is inserted into the outlet and
turned on.
- The machine is ON and in the ready state.
• Descaling
1. Press the 2 CUP button and allow the
descaling solution to pour through. Then
turn the dial to HOT WATER and allow
approximately 100mL of water to pour
through.
2. Press the STANDBY button to turn off the
machine.
3. Leave the descaling solution in the machine
for 5 minutes.
4. Press the STANDBY button to turn on the
machine.
5. Repeat Step 1 three times.
6. Discard the descaling solution and rinse the
water tank with water.
7. Fill the water tank with water to the MAX
level.
8. Repeat Step 1 two times with water.
9. After descaling, cancel the descaling
warning by simultaneously pressing the 1
CUP, 2 CUP and STEAM buttons for
3 seconds.
• Cancel the descale warning
- After descaling, cancel the descale warning
by simultaneously pressing the 1 CUP, 2 CUP
and STEAM buttons for 3 seconds.
27