Parts Of Image Missing Or Surrounded By Extra White Areas; Trouble Scanning With Multi-Scan Or Multi-Crop Function; Slow Scanning Speed - Canon PIXMA MP500 User Manual

Cause
The status of the original is poor.

Parts of image missing or surrounded by extra white areas

Cause
Scan area was specified larger than
the original.

Trouble scanning with Multi-Scan or Multi-Crop function

Cause
The original is positioned outside
the supported area.
Error arising from application
software specifications.

Slow scanning speed

Cause
Resolution is set higher than
necessary.
Image correction features such as
dust and scratch reduction, fading
correction, and descreening are
enabled in ScanGear MP.
128 Troubleshooting
Scan with certain functions such as [Remove Dust and Scratches],
[Fading Correction] or [Grain Correction] in the [Image Settings] section of
the Advanced Mode of ScanGear MP.
Note
If a print out of an image does not appear satisfactory or the same as what
you see on the monitor, you may need to change the machine's settings,
or the machine itself may have engaged in problems.
Specify the scan area appropriately.
If you click the Auto crop button of the ScanGear MP, the scan area is
adjusted automatically to match the size of the original. When scanning an
original surrounded by white borders such as a photo print, of if you
otherwise want to specify a custom scan area, specify the scan area
manually. Refer to the Scan Guide for details on manual scan area
specification.
Check the position of the original on the document glass. Observe the
following when using the Multi-Scan or Multi-crop function.
Keep more than 3/8 inch (10 mm) between the Originals, and the
Originals and the edge of the platen glass.
A maximum of 10 originals can be scanned at once.
If an original is slightly crooked on the platen-within 10 degrees of true-
the image is automatically straightened.
The Multi-Scan function only works with rectangular originals such as
photos.
Originals that are not rectangular (irregularly shaped, close-cropped
photos) cannot be detected correctly.
Some application softwares do not support multiple image scanning.
Scan each item individually without using the Multi-Scan or Multi-Crop
function.
To view the image on a monitor, set the Output resolution to 75 dpi. To
print, set the Output resolution to a value such as 300 dpi.
Set [Reduce Dust and Scratches], [Fading Correction], and [Descreen] to
[OFF] in the [Image Settings] section of the Advanced Mode of ScanGear
MP.
Action
Action
Action
Action
Chapter 11