Skil PWRCORE DL6293B-00 Owner's Manual page 15

To install the bit:
a. Rotate the chuck body counterclockwise,
viewed from chuck end, to open the chuck to
approximately the drill bit diameter.
b. Insert a clean bit up to the drill-bit flutes for
small bits, or as far as it will go for large bits.
Close the chuck by rotating the chuck body
clockwise and securely tighten it by hand
(Fig. 8a).
To remove the bit:
a. Rotate the chuck body counterclockwise,
as viewed from the chuck end, to open the
chuck.
b. Remove the bit.
WARNING
chuck as shown in Fig . 8b . This could cause the drill bit to be thrown from the tool, resulting
in possibly serious personal injury or damage to the chuck.
WARNING
Removable Belt Clip (Fig. 9)
Your tool is shipped with a removable belt clip
that can be positioned on either side of the tool
for convenient transportation.
To install the belt clip onto the tool:
a. Remove the battery pack from the tool.
b. Align the rib and the hole of the belt clip with
the opening and the threaded hole on the
base of the tool, respectively.
c. Insert the screw and securely tighten the
screw with a screwdriver (not included).
To remove the belt clip from the tool:
a. Remove the battery pack from the tool.
b. Use a screwdriver (not included) to loosen the screw that attaches the belt clip to the tool.
c. Remove the screw and the belt clip. Keep them in a safe place for future use.
Make sure to insert the drill bit straight into the chuck jaws . Do not
insert the drill bit into the chuck jaws at an angle and then tighten the
The bit may be hot after prolonged use . Use protective gloves when
removing the bit from the tool, or first allow the bit to cool down .
Fig . 8b
Fig . 9
Removable
Belt Clip
Opening
Rib
15