Skil PWRCORE DL6293B-00 Owner's Manual page 14

WORKLIGHT (Fig. 7)
Your tool is equipped with a WORKLIGHT light,
located on the base of the tool. This provides
additional light on the surface of the workpiece
for operation in lower-light areas.
The WORKLIGHT will illuminate in default, low
brightness mode when the tool is turned on
OR if the WORKLIGHT button is depressed
without turning the tool on. You can switch the
brightness from low to full or from full to low by
pressing the WORKLIGHT button.
NOTE: WORKLIGHT will turn off automatically
after 10 seconds of inactivity. In full brightness
mode WORKLIGHT will turn off automatically
after 10 minutes of inactivity.
NOTE: For safety reasons, the WORKLIGHT
button is disabled while the tool is running. The brightness should only be switched when the
tool is not running.
The WORKLIGHT will rapidly flash when the tool and/or battery pack becomes overloaded or
too hot and the internal sensors will turn the tool off. Rest the tool for a while or place the tool
and battery pack separately under air flow for cooling.
The WORKLIGHT will flash more slowly to indicate that the battery pack charge is low.
Recharge the battery pack.
Installing and Removing Bits (Fig. 8a & 8b)
WARNING
attempting to grasp the spinning chuck.
WARNING
in the chuck jaws. The arrow on the chuck indicates the direction in which to rotate the chuck
body in order to lock ("CLOSE") or unlock ("OPEN") the chuck jaws on the drill bit.
a. Lock the trigger switch "OFF" on the tool by placing the direction-of-rotation selector in the
center position.
b. Remove the battery pack and rotate the torque-adjustment ring to the drill setting "
Fig . 8a
Unlock ("OPEN")
14
Do not use the power of the drill driver while grasping chuck to
loosen or tighten the bit . Friction burn or hand injury is possible if
Do not use bits with damaged shanks .
Your tool is equipped with a keyless chuck to tighten or release drill bits
Fig . 7
WORKLIGHT
WORKLIGHT Button
Lock ("CLOSE")
".