Table of Contents
Advertisement
SAFETY
Please wear all required personal protective equipment
according to OSHA regulations, and be sure to comply with
the precautions described in this manual to protect you and
others from possible harm. The ANSI definitions below detail
and clarify the magnitude and urgency of potential harm, dam-
age and problems arising from misuse or improper installation.
Relative to their potential danger, the definitions are divided
into four parts as defined by ANSI Z535 Series.
ANSI Z535.5 DEFINITIONS
• DANGER – Indicate[s] a hazardous situation
which, if not avoided, will result in death or
serious injury.
• WARNING – Indicate[s] a hazardous situ-
ation which, if not avoided, could result in
death or serious injury.
• CAUTION – Indicate[s] a hazardous situation
which, if not avoided, could result in minor
or moderate injury.
• NOTICE – Not related to personal injury –
Indicates[s] situations, which if not avoided, could
result in damage to equipment.
REVISION HISTORY
REVISION J — Added new horizontal ULTRA
LEDs
BEFORE YOU BEGIN
Read the safety information completely and carefully.
Working Near the Public
Cordon off all work areas with cones, caution tape, warning
signs and/or barricades. Maintain a work area of at least 5
feet from the public. Is a second person required to prevent
the public from entering the work area when the work area
cannot be adequately cordoned off?
Electrical Hazards
Are all live electrical hazards protected from public access;
i.e., de-energized/locked out or cordoned off? Is proper
signage in place? Make sure the work area is cordoned
off.
Electrical / LOTO
Does the project require you to work with live electricity?
If yes, have you received appropriate training? Do you
have appropriate locks and tags to de-energize or isolate
the electrical supply?
• Read and observe all CAUTIONS and WARNINGS shown
throughout these instructions.
• Each person working on or near the installation
described must wear safety glasses or goggles.
• Block access to the work area by customers or other
personnel to prevent injury.
• Read and follow all industry safety recommendations
and established procedures.
• Wiring must be 2 wire with ground and rated for
75°C (176°F).
Advertisement
Table of Contents
