Advertisement
7. Using a 10 mm socket wrench, remove the 5 screws
(4) from the flange (29). Using your hand, firmly
grasp the end of the displacement rod (30) and
remove the entire assembly from the air cylinder
(27) (Fig. 5).
NOTE: Sliding the flat blade of a screw driver
between the flange (29) and air cylinder (27) will
help separate the two parts. Exercise caution, how-
ever, to not damage the o-ring (6).
6
Fig. 5
8. Remove the air cylinder (27) from the vise.
3A1494D
29
4
30
9. Lay the flange assembly on a hard, clean work sur-
face. Use an adjustable wrench to hold the displace-
ment rod (30) securely in place. Use a 13 mm
wrench to loosen bolt (18). Remove bolt (18) and
washer (19) (Fig. 6 and Fig. 7).
NOTE: Do not use a hex wrench on the oil piston
(33) or ball holder (34) to loosen or tighten. Using a
hex wrench on this part could cause the pin (10)
(Fig. 7) to fail.
21
29
Fig. 6
10. Pull the air piston (21) and o-ring (55) off the dis-
placement rod (30).
11. Pull the displacement rod (30) out of flange housing
(29).
21
18
19
55
Fig. 7
Instructions
34
33
29
30
30
33
5
Advertisement
