Advertisement
Instructions
NOTE:
•
The bearing (22) is not included in the kit. This
part is reused. The bearing can be installed with
either side facing up. There is not just one way
to install this part.
•
The bearing (22) is a transitional fit and in some
installations it may not be removed.
•
Be sure u-cup seal (9) is installed with the lips
facing down as shown in Fig. 21.
9
Lips down
22
26
Fig. 21
3. Remove and discard the 3 small o-rings (17) in the
bottom cover (26) (Fig. 22). Grease the new o-rings
(17) included in the kit and install them in the bottom
cover housing.
26
Fig. 22
4. Use a pick to remove o-rings (8) and (14) from the
flange (29). (Fig. 23). Grease and replace the
o-rings as shown in Fig. 23.
10
29
6
7
Fig. 23
5. Reassemble the pump as described in the Reas-
sembly instructions, page 6.
17
8
29
14
3A1494D
Advertisement
