Table of Contents
Advertisement
14
Keys, Doors, and Windows
Mechanical Key Access
To access a vehicle with a
weak remote key battery, see
Door Locks 0 18.
Programming Remote
Keys to the Vehicle
Only remote keys programmed
to the vehicle will work. If a
remote key is lost or stolen, a
replacement can be purchased
and programmed through your
dealer. The vehicle can be
reprogrammed so that lost or
stolen remote keys no longer
work. Each vehicle can have
up to eight remote keys
matched to it.
Starting the Vehicle with a
Low Remote Key Battery
For improved vehicle security,
the remote key is equipped
with a motion sensor. When
starting the vehicle, if the
remote key has been idle for a
while, the DIC may display KEY
IN SLEEP MODE, MOVE KEY,
THEN START. Move the
remote key slightly and try
starting the vehicle. When
starting the vehicle, if the
remote key battery is depleted
or there is signal interference,
the DIC may display NO KEY
FOUND, REPLACE BATTERY
IN KEY or NO REMOTE KEY
WAS DETECTED PLACE KEY
IN KEY POCKET THEN START
YOUR VEHICLE, follow the
steps shown below:
1. Place the remote key into
the rear cupholder.
2. With the vehicle in P (Park)
or N (Neutral) press the
brake pedal and ENGINE
START/STOP.
Replace the remote key
battery as soon as
possible.
Battery Replacement
Warning
Never allow children to play
with the remote key. The
remote key contains a small
battery, which can be a
choking hazard. If swallowed,
internal burns can occur,
resulting in severe injury or
death. Seek medical
attention immediately if a
battery is swallowed.
Warning
To avoid personal injury, do
not touch metal surfaces on
the remote key when it has
been exposed to extreme
(Continued)
Advertisement
Chapters
Table of Contents
