Changing From A Minitower To A Desktop Configuration - HP Compaq dc7700 MT Hardware Reference Manual

Changing from a Minitower to a Desktop Configuration

1. Remove/disengage any security devices that prohibit opening the computer.
2. Remove all removable media, such as diskettes or compact discs, from the computer.
3. Turn off the computer properly through the operating system, then turn off any external devices.
4. Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION
board as long as the system is plugged into an active AC outlet. You must disconnect the
power cord to avoid damage to the internal components of the computer.
5. Remove the computer access panel.
CAUTION
right of the DIMM sockets. If the LED is illuminated, the system still has power. Turn off the
computer and remove the power cord before proceeding.
6. Remove the front bezel.
7. Disconnect all power and data cables from the back of the drives in the 5.25-inch drive bays.
8. To release the drives from the 5.25-inch drive bay, lift the release tab on the green latch drive
bracket for the drive. While lifting the release tab, slide the drive from its drive bay. Repeat this step
for each 5.25-inch drive.
Figure 2-24
36 Chapter 2 Hardware Upgrades
Regardless of the power-on state, voltage is always present on the system
After removing the access panel, look for the LED on the system board to the
Releasing the 5.25-inch Drives from the Drive Bays (Minitower)
ENWW