HP Compaq dc5700 SFF Hardware Reference Manual page 25

11. Open both latches of the memory module socket (1), and insert the memory module into the socket
(2).
Figure 2-10
NOTE
with the tab on the memory socket.
For maximum performance, populate the sockets so that the memory capacity is spread as
equally as possible between Channel A and Channel B. Refer to
Sockets
12. Push the module down into the socket, ensuring that the module is fully inserted and properly
seated. Make sure the latches are in the closed position (3).
13. Repeat steps 11 and 12 to install any additional modules.
14. Replace the access panel.
15. If the computer was on a stand, replace the stand.
16. Reconnect the power cord and any external devices, then turn on the computer. The computer
should automatically recognize the additional memory when you turn on the computer.
17. Lock any security devices that were disengaged when the access panel was removed.
ENWW
Installing a DIMM
A memory module can be installed in only one way. Match the notch on the module
for more information.
Populating DIMM
Installing Additional Memory 19