Replacing The Cover - HP Brio BA300 Upgrade Manual

Upgrading and Replacing PC Hardware

Replacing the Cover

1 Pull the bottom edges of the PC cover apart slightly.
2 Lower the cover onto the PC, leaving a gap of about 1cm (0.3 inches) between the cover and the front
of the PC.
3 Make sure that the protruding metal tab at the rear of the PC chassis fits through the slit on the top
right of the cover.
4 When you are sure that the bottom sides of the cover fit correctly into the guide rails, slide the cover
towards the front of the PC.
5 Tighten the three screws on the back of the PC.
10