Wp810 Web Gui Access Configuration; Configuration Via Web Browser; Accessing The Web Ui - Grandstream Networks WP810 User Manual

WP810 WEB GUI ACCESS CONFIGURATION

The WP810 can be configured using:

Web GUI embedded on the WP810 using PC's web browser.

LCD Configuration Menu using the WP810 keypad.
Note: From the Web GUI, you can configure all the functions supported by the WP810; while via keypad
menu, you can access limited configuration.

Configuration via Web Browser

The WP810 embedded Web server responds to HTTP/HTTPS GET/POST requests. Embedded HTML
pages allow a user to configure the WP810 through a Web browser such as Google Chrome, Mozilla Firefox.
Note: Please note that Microsoft's IE 9 and below are not supported, also the records from the web cannot
be played with IE10, Edge and Safari. We highly recommend using Google Chrome or Mozilla Firefox.

Accessing the Web UI

1. Connect the computer to the same network as WP810.
2. Make sure the WP810 is booted up and powered correctly.
3. You may check WP810 IP address via a subscribed WP810 on its LCD menu Status  Network
Status. Please see [WP810 Network ]
4. Open Web browser on your computer and enter the WP810 IP address in the address bar of the
browser.
5. Enter the administrator's username and password to access the Web Configuration Menu.
Notes:
-
The computer must be connected to the same sub-network as the WP810. This can be easily done
by connecting the computer to the same hub or switch as the WP810.
The default administrator username is "admin", and the random password can be found on the
-
sticker at the back of the unit. the default end-user username is "user" and the password is "123".
If 'Disable web UI access' parameter is enabled under Advanced settings  System security;
-
web UI access will be disabled.
WP810 User Guide
Version 1.0.7.83
P a g e | 30