Lcd Touch Panel - Panasonic MCO-170M Series Operating Instructions Manual

INCUBATOR COMPONENTS
22. Power supply cord cover plate: This plate is to prevent the power cord being come off.
23. USB port: Insert USB memory to export operations and alarms log. Refer to page 53～61.
Note: It is impossible to use USB memory which is required password input.
24. Access port: Place the silicon caps on both outside and inside of the port when the port is not being
used.
25. Remote alarm terminals: This terminal informs the alarm to remote location by connecting to external
alarm unit. Refer to page 15.

LCD touch panel

The following display (called the Top screen) will appear when the power switch is turned ON.
Note: It takes approximately 20 seconds until Top screen is displayed. During warming-up, "Status: Gas
sensor initializing" is displayed in the Message display field (18), and "--.-" is displayed in the present CO
density display field (5) and the present O
3
1
1. Present temperature display field
The current chamber temperature is displayed.
2. Set temperature value display field
The set value of chamber temperature is
displayed. Default setting: 37
12
density display field (10).
2
2
o
C.
3. Heating indicator
This lamp lights when the heater is energized.
4. Present date/time display field
Normally, this indicator shows date and time. The
date and time is simply set when the incubator is
shipped from the factory. Refer to page 62 for
details.
2
4