Table of Contents
Advertisement
Parts and Their Functions
Front panel
ON
OFF
1 POWER switch
This is used to switch the power ON and OFF.
Do not switch the power back on immediately after
switching it off. After the power has been switched
off, wait at least 5 seconds before switching it back
on.
2 Display panel
Format display:
Indicates the codec format.
Status display:
Indicates the codec status (video/audio input,
time code, etc.).
When either of the scroll buttons 4 is pressed,
the display can be scrolled to the left or right.
Setup menu display:
The setup menu is displayed when the MENU
button 8 is pressed.
3 Input condition lamp
This lights or flashes depending on the condition of
the input signals.
Lit
: The lamp lights when all the necessary
signals are input.
Flashing : The lamp flashes when the video signals
(HD SDI or SDTI) are input but the other
audio signals and/or reference signal are
not input.
Off
: The lamp is off when the video signals are
not input.
4 Scroll buttons
These enable the display to be scrolled to the left or
right when the status is displayed on the display
panel.
5 ENTER button
This is pressed to enter a setup menu setting after
that setting has been selected.
6 ESCAPE button
This is pressed to ignore or cancel a setup menu
setting after that setting has been selected.
1
POWER
INPUT
3
2
8
;
< ;
MENU
SET
ENTER
ESCAPE
SHIFT
4
5 6 7
9
<
7 SHIFT button
This is pressed together with the [#] button or [2]
button to change the mode (encoder/decoder, etc.)
during the setup menu setting process.
8 MENU button
This is pressed when a setup menu is to be
operated.
When it is pressed, the setup menu number and
item appear on the display panel.
When a video monitor has been connected to the
HD SDI OUT3 connector or SD SDI OUT3
connector, the setup menu will appear on the
monitor screen.
When the MENU button is pressed again, the setup
menu setting mode is finished and the original
status is restored.
9 SET button
This is pressed to enter a setup menu setting after
that setting has been selected. When the setup
menu data is entered, the setup menu setting mode
is finished and the original status is restored.
: DIAG button
This is used to display the unit 's information on the
monitor screen when a video monitor has been
connected to the HD SDI OUT3 connector or SD
SDI OUT3 connector.
When the DIAG button is pressed again, the
original status of the screen display is restored.
For further details, refer to "Warning messages and
DIAG display." (See page 19)
; Left [!] and right [1] buttons
These are used to select a setting during the setup
menu item setting process.
< Up [#] and down [2] buttons
These are used to select an item during the setup
menu item setting process.
4
:
DIAG
Advertisement
Table of Contents
