Table of Contents
Advertisement
Presenting from a Media Reader
The USB port on the projector allows you to browse the image and document files stored on a USB
flash drive connected to the projector. It can elimate the need for a computer source.
Supported files formats
Video format
• MPEG1
• MPEG4
• H.263
• Motion JPEG
Viewing files
1. Plug a USB flash drive into the MEDIA READER port of the projector.
2. Press SOURCE and select Media Reader. The projector displays the built in media reader main
page.
3. Press / / / to select and press OK to enter the sub-folder or display a file.
4. After a file is displayed, press OK to call out the function bar. You can press / to select the
function and press OK to enact the selected item.
Shutting down the projector
1. Press
on the projector or
control and a confirmation message will appear
prompting you. If you don't respond in a few seconds, the
message will disappear.
2. Press
or
indicator flashes orange, the projection lamp shuts down,
and the fans will continue to run for approximately 90
seconds to cool down the projector.
3. Once the cooling process finishes, the power indicator
becomes a steady orange and fans stop. Disconnect the
power cord from the power outlet.
• To protect the lamp, the projector will not respond to any commands during the cooling process.
• Avoid turning on the projector immediately after turning it off as excessive heat may shorten lamp life.
• Lamp life results will vary depending on environmental conditions and usage.
Direct power off
The AC power cord can be pulled out right after the projector is turned off. To protect the lamp, wait
about 10 minutes before re-starting the projector. If you attempt to re-start the projector, the fans may
run for a few minutes to cool down. In such cases, press
after the fans stop and the power indicator turns orange.
26
Operation
Audio format
• MPEG1/2 Layer1
• MPEG1/2 Layer2
• FLAC
/
/
a second time. The power
Photo format
• JPEG Base-line
• JPEG Progressive
• PNG non-interlace
• PNG interlace
• BMP
on the remote
or
/
again to start the projector
Advertisement
Table of Contents
