Table of Contents
Advertisement
Step 1:
Specify Projector Position.
For more information about projector position, see
Choosing a
location.
Step 2:
Specify OSD Language.
Step 3:
Specify Vertical Keystone.
4. If you are prompted for a password, press the arrow keys to enter a 6-digit password. See
the password function on page
5. Switch all of the connected equipment on.
6. The projector will search for input signals. The current input signal being scanned appears. If the
projector does not detect a valid signal, the message "No Signal" will continue displaying until an
input signal is found.
You can also press SOURCE to select your desired input signal. See
25.
• Please use the original accessories (e.g. power cord) to avoid possible dangers such as electric shock and fire.
• If the projector is still hot from previous activity, it will run the cooling fan for approximately 90 seconds before
energizing the lamp.
• The Setup Wizard screenshots are for reference only and may differ from the actual design.
• If the frequency/resolution of the input signal exceeds the projector's operating range, you will see the message
"Out of Range" displayed on the background screen. Please change to an input signal which is compatible with
the projector's resolution or set the input signal to a lower setting. See
• If no signal is detected for 3 minutes, the projector automatically enters saving mode.
20
Operation
24.
Switching input signal on page
Timing chart on page
45.
Utilizing
Advertisement
Table of Contents
