Extended Menu
User's Logo
Extended > User's Logo
s
You can save an image on the projector and display it whenever the projector
turns on. You can also display the image when the projector is not receiving
an input signal. This image is called the user's logo screen.
You can select a photo, graphic, or company logo as the user's logo, which is
useful in identifying the projector's owner to help deter theft. You can prevent
changes to the user's logo by setting up password protection.
Display the image you want to project as the user's logo and then select this
setting.
• If the User's Logo Protection setting in the Password Protection
setting menu is set to On, set to Off before saving the user's logo.
a
• When you copy the menu settings from one projector to another
using the batch setup feature, user's logo is also copied. Do not
register the information that you do not want to share between
multiple projectors as a user's logo.
• You cannot save content that is protected by HDCP.
• When Content Playback is set to On, you can display the user's logo
only when the projector starts up.
• Adjustments for image shape and display range are temporarily
canceled when you select User's Logo.
Projection
Extended > Projection
s
You can set the way the projector faces the screen so the image is oriented
correctly.
You can change the projection mode to flip the image over top-to-
bottom by holding down the [A/V Mute] button on the remote control
for approximately 5 seconds.
a
Direct Power On
Extended > Operation > Direct Power On
s
Set to On to turn on the projector by plugging it in without pressing the
power button.
Note that the projector also turns on automatically in cases such as recovery
from a power outage.
Sleep Mode
Extended > Operation > Sleep Mode
s
Set to On to automatically turns off the projector after an interval of
inactivity.
Sleep Mode Timer
Extended > Operation > Sleep Mode Timer
s
You can set the time before the projector automatically turns off from 1 to 30
minutes.
This function is enabled only when Sleep Mode is set to On.
a
High Altitude Mode
Extended > Operation > High Altitude Mode
s
When operating the projector at an altitude where the air is thin, the normal
rotation speed of the fans is not enough to cool the projector.
Set to On to increase the rotation speed of the fans at altitudes above 1500 m.
95