Table of Contents
Advertisement
Attaching and Removing a Lens
If you are projecting from a table or other flat surface, the image may
be tilted depending on your lens. Adjust the tilt of the image using the
front and rear feet.
a
Removing a Lens
You can remove a lens to replace it with a different lens.
Caution
Wait at least 30 minutes to remove or replace the lens after turning off the
projector. Touching the lens unit before it cools down may cause burns.
The projector uses a laser as the light source. As a safety measure, the
light source turns off when the lens is removed. Attach the lens, and
then press the [On] button to turn it back on.
a
a
Hold down the [Lens Shift] (remote control) or [Lens] (control panel)
button for approximately 3 seconds to move the lens to the home
position.
b
Turn off the projector and unplug the power cord.
c
Remove the lens replacement cover.
d
If necessary, loosen the screw next to the lock lever.
34
Advertisement
Table of Contents
