International comfort products F9MVE Installation Instructions Manual page 13

INSTALLATION INSTRUCTIONS
Figure 8 Upflow Trap Configuration
Collector Box
Plugs
Figure 9 Unconverted Factory Configuration as viewed in the Downflow Orientation
Remove relief tube from relief
port on condensate trap.
Remove the screw
that secures the trap
to the collector box and
remove trap.
Loosen clamp on inlet
to vent elbow.
440 01 4400 03
Vent Pipe Clamp
Condensate Trap
Relief Port
UPFLOW TRAP CONFIGURATION
1 & 2 Stage Units
Representative drawing only, some models may vary in appearance.
Remove pressure switch tube from
front pressure switch and discard. A
new tube is shipped in the loose parts
bag.
Representative drawing only, some models may vary in appearance.
Specifications subject to change without notice.
Gas Furnace: (F/G)9MVE
Vent Elbow
Collector Box
Condensate Trap
Condensate Trap
Pressure Switch
Port
Remove tube from relief port.
Remove middle and bottom
plugs. DO NOT DISCARD.
Vent Elbow Clamp
Plug
Relief Port
Outlet
A11307
A11587LA
13