To Recalibrate The Plotter; To Restore The Factory's Calibration - HP Designjet 700 User Manual

Reconfiguring Your Plotter
Recalibrating the Plotter for Accuracy

To Recalibrate the Plotter

1 Choose your media type (sheet or roll). If recalibrating for a non-standard media
Utilities
type, use that type. Otherwise, HP Matte Film will give greatest accuracy.
2 Choose your media size. Sheet media must be either E/A0 or D/A1.
Accuracy
3 Go to
Recalibrate
4 Choose
Full menu mode
loaded, this will be ejected. If roll media is loaded, you are asked to remove it.
only
5 When prompted, load your media, using the normal procedure. If using sheet
media, load it in portrait orientation, unless you chose D/A1-size media for an
E/A0-size plotter, in which case load it in landscape orientation.
6 When the calibration plot is finished, remove it.
7 Unload any unplotted media.
8
Rotate the calibration plot 90 counterclockwise and reload it printed side
down, so that the black arrows go into the plotter first. NOTE: Even if you
selected roll media in step 5, this time you must select sheet media.
9 Go to
10 When the plotter has finished measuring and has ejected the sheet,
is displayed. The recalibration routine is finished.

To Restore the Factory's Calibration

From the
Utilities
Accuracy
Restore factory
Full menu mode only
7-6
in the front-panel menus, as shown above left.
Recalibrate
Create pattern . The message
1
again and, this time, choose
Recalibrate
Accuracy menu, choose
Calibrating is displayed. If sheet media is
2
Measure pattern
Restore factory . That's all.
3
0030
.
STATUS/Ready