Table of Contents
Advertisement
ETH MODEM
y Connect the DATA jack of the TV to the
✎ The "ETH MODEM" jack name that you connect the Data Cable to may differ depending on the SBB or STB type.
y IR signals sent by the remote control to the TV or SBB / STB must meet the following specification to use IR pass
through function.
IR signal receiver specification
– Band pass filter center frequency: 37.9 ㎑
– Carrier Frequency, Duty 50%
– Minimum Burst Length (tburst): 12 pulses (316 us)
– Minimum Gap Time Between the burst (tburst gap): 16 pulses (422 us)
– Minimum Gap Time between the data commands (tpause): 25 ㎳
26
English
Connecting the TV to an SBB or STB
Data Cable
ETH MODEM
jack of the STB (SBB) with the Data cable.
TV Rear Panel
Advertisement
Table of Contents
