Connecting The Tv To A Sbb Or Stb - Samsung HG43Q60A Install Manual

Connecting the TV to a SBB or STB

STB (SBB)
ETH MODEM
Connect the DATA port of the TV to the ETH MODEM port of the STB (SBB) with the Data cable.
• The ETH MODEM port name that you connect the Data Cable to may differ depending on the SBB or STB type.
• IR signals sent by the remote control to the TV or SBB / STB must meet the following specification to use IR pass
through function.
IR signal receiver specification
– Band pass filter center frequency: 37.9 ㎑
– Carrier Frequency, Duty 50%
– Minimum Burst Length (tburst): 12 pulses (316 us)
– Minimum Gap Time Between the burst (tburst gap): 16 pulses (422 us)
– Minimum Gap Time between the data commands (tpause): 25 ㎳
List of Hospitality SI Vendors and compatible data cables supplied with the TV
• Confirm you are using the correct data cable for your SI vendor. Refer to the code label on the data cables.
• Contact your nearest dealer or your SI Vendor to buy the data cable not included in the TV.
TV side
5
4
3
2
1
Cable code
BN39-02462A
(Color : BLACK)
BN39-02461A
(Color: LIGHT GRAY)
• RX and TX notation is based on TV.
• Operation Specification of Data Cable(RJ12): RS232
Confirm the code on the Code Label.
TV SIDE
1: NC
2: RX
3: TX
4: IR
5: GND
TV SIDE
1: CLK
2: RX
3: TX
4: IR
5: GND
English - 24
Data Cable
Pin assign
P1 P2 STB (SBB) SIDE
RED
1 3
GREEN
2 5
WHITE
3 6
BLACK
4 1
YELLOW
5 2
P1 P2 STB (SBB) SIDE
RED
1 6
GREEN
2 5
WHITE
3 3
BLACK
4 1
YELLOW
5 2
TV Rear Panel
STB (SBB) side
1
6
REMARK
1: IR
SAMSUNG and
2: GND
3: NC
4: NC others
5: RX
6: TX
1: IR
2: GND
MTI
3: TX
4: NC
5: RX
6: CLK