Antenna Connection - JVC LT-24HA47E Operating Instructions Manual

Antenna connection

Note: Before you connect other appliances:
• To avoid potentially damaging your set, make sure all items are switched off and disconnected from the
mains power when you make the connections.
• Arrange the desired connection.
• When you have finished making the connections, reconnect the mains power to the unit and switch it
back on.
Connect your antenna as shown below (C). Connections to other equipment is explained further on
P.26-27. If you have problems with reception, consult a specialist of antenna.
Back Side
(D)
(E)
(F)
(G)
(H)
(D)
(E)
(F)
(G)
(H)
*¹ M4x10
*² 100x100mm
*³ Screws
EN 10
LT-24...
100 mm
(I)
(J)
LT-29.../LT-39...
200 mm* ²
(J* ³ )
LT-29...
(J)
M4 x 10
100 mm
M6* ¹ x 10
(I)
100 mm
(A) AUDIO IN: Input
for Audio input for
(A)
component/AV (Sharing).
See P.26-27.
(B) DIGITAL AUDIO
(B)
COAXIAL output: digital
audio output. See P.26.
(C)
(C) ANT. CABLE: Connect
an antenna.
The built-in tuner
receives all analogue
cable programmes and
DVB-T/-C channels.
(D) HEADPHONE jack: Plug
headphones with a mini
plug (3.5 mm) into this
jack.
(E) USB input: See P.22-25.
Use of this port by other
than Service Personnel
may void this products
warranty.
(F) HDMI (LT-29.../LT-39...:
HDMI1/2/3) input: See
P.26.
(F)
(G) Y(VIDEO)/Pb/Pr input:
Input for analogue
Component-Signal. See
P.26-27.
Note: AV-CVBS input is
(A)
sharing with component
input.
(B)
(H) C.I. slot: for CA- module
(CAM) (if PayTV-provider
supports this).
(C)
Note: To prevent
malfunctions and
damages, be sure to
turn off the TV before
inserting or removing the
CAM card.
(I) Bracket holes: Fix a wall
mounting bracket (not
supplied) here.
(J) To hang the television
on a wall, remove these
screws and then remove
the stand.
Before performing work
spread cushioning over
an area to lay the TV on.